FOR CLARITY OF MEANING:
Post Production is great but 'the answer' relies on getting it all OK in the neg.
That’s been my main message here and is the main message in most threads where I modify an existing image for illustrative/educational purposes.
*
In arduous shooting condition or when shooting under the pressure of time I think that two elements of brain focus are very important regarding the technical aspects about the capture:
1. don't blow-out anything, or as little as possible (and use as low an ISO as possible)
2. get it all in the frame (shoot wide, crop later)
Then with all that data at your disposal and if the shot is worthwhile to you, work in the darkroom at it – and usually that work is much longer than 15 minutes.
*
EXAMPLES
1. don't blow-out anything, or as little as possible (and use as low an ISO as possible):
because it is easier to reclaim detail already present in the shadow areas than to rebuild blown-out areas it is usually best to use a low ISO and not blow any highlights, for example, when there is dappled light:
2. get it all in the frame (shoot wide, crop later)
It is usually easier to crop, align, re-fabricate or remove what is in the image, rather than having to rebuild what is not in the image (note my mistake at the time of capture top RH corner of Building):
*
Post Production time was about 4 hours for each of the above.
The castle went through two iterations because I didn’t have a clear vision when I made the shot.
For the house, my vision was very clear when I saw it: I just knew it would be a lot of work and I was so annoyed that I clipped the top RH corner, just three big steps back would have saved at least 20~30 minutes.
WW